What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
10.06.2025 07:16

(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
At one ohm, the resistor has a maximum of 1 watt power.
The MOV will conduct when the voltage exceeds 50% of line voltage.
How far back into your childhood can your remember and what is your favorite memory of that time?
This is 'the assistant's answer'
2024–10–10[John johnson John Johnson ]
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
What are the most outrageous violations of restaurant buffet etiquette have you seen?
Here is a simplified AC power diagram.
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
A Glucose Monitor for Someone Without Diabetes: Optimal or Overkill? - WSJ
eight
He then describes Rainy Season and Lightning.
Upvotes:
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
the problem then depends on "how fast does the fuse operate?".
He then describes the function of a fuse.
What do you think of Obito Uchiha?
but I think this circuit , shows a few more pieces.
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
Italy citizenship referendum polarises country - BBC
(Dc diagram shown, AC is similar).
nine
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
What is the scariest thing that ever happened in your life?
Now when you have a certain ac resistance, then a current flows in a loop.
a photo is worth a thousand words.
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
Have you had any paranormal activity situations happen personally to you or someone you know?
These devices are installed between the “hot” and “neutral” and protective ground.
What is lightning?
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
Why is there no great temptress figure in any of Tolkien’s major works?
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
It seems Mohan does not understand the difference between a comment and an Answer.
This device then solves the entire problem.
so, what happens?
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
These are simplified answers to the original question, and does not change anything I wrote above.
What To Expect in the Markets This Week - Investopedia
One is “what exactly is in a ‘surge protector’ ? ”
One
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
In schematic diagrams this is the symbol for a fuse:
He then asserts :
2024–10–16 [ OO OLAOYE OYEBODE ]
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
[old diagram got deleted by accident]
The third is lightning and “how it gets conducted into a home.”
What does a fuse do?
There are two important concepts here.
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
This one hit behind the barn.
It also is a device that limits the change in current flow.
what exactly is a ‘surge’ protector?
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
Because the load is inductive, the current lags the voltage.(by a bit).
But… the neutral is now “floating” because of the 1 ohm resistance.
This is where the MOV conducts again, and dissipated the energy.
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
An AC voltage/ current source, and an ac inductive load.
Can the fuse protect the electronic devices from lightning instead of a surge protector.
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
A circuit breaker is similar, but is resettable.
Barnstars:
For this case there are devices called Metal oxide varistors (MOV).
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
The other is “what does a “fuse” do?”
First Sentence:
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
2024–10–14 [Omar Gharbi Omar Gharbi ]
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
The bolt then partially travels down the line to your home.
This is the picture of an electronic coil of wire wound around a core of magnetic material.
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
But it can get overloaded, and no longer works.
So, the voltage could go up to 500 volts, and the fuse will not open up.
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
A fuse is a non-resetable over current circuit protector.
There are three different concepts here that are getting confused.
Edit 2024–10.
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
This is where this question deviates from being a 'generic' question, and becomes more specific.
At least they know the answer if they wanted it.
[image of Common-mode choke]
but this device (an Inductor) … impedes the rapid changes in the current.
I post the exact comment here.